![]() The computer detected the device Autocom CDP+ BT 100953 and the pairing is ok with pin 0000, but when I try to connect to the car it says the same as with usb: the vehicle is not reponding and relay are clicking with Lights changes from blue to green and it take more than a minute to get error not responding.ģrd try: I removed the FTDI232RL from the bord hoping that may be there is a short or someting but the same relay clicking and no response. So I gave up and tried to use bluetooth because i think it will work but it did not work. The driver from cd is not accepted (because it is fake ftdi with fake serial number A50285BI) When plugged to usb it is installed as the standard FTDI driver as serial prot and not as VCI diagnostic. I found that the FTDI chip is fake because it does not sotre the settings with Mprog 3.5 and it does not have EEprom inside as Mprog reported that no EEPROM found. ![]() I Have this same board and could not get it to work neither on usb nor on Bluetooth. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |